mo.switch mini

The mo.switch mini is a universal, small push-button fitting for handlebars with a 1 inch or 22 mm (7/8 inch) tube diameter with an attractive look.

Very small and narrow but very striking thanks to the elaborate contrast cut. The housing, which is milled from a solid piece, is first anodized and then milled over at the edges.

3 miniature buttons with a defined pressure point are embedded in recesses that provide the thumb with the necessary orientation. The push buttons are protected against splash water and are very robust.

The individual wires are also already soldered ready for use and sealed watertight. All that remains to be done is to drill a hole in the handlebars for the thin cable. With a cable length of two meters, there are sufficient reserves for installation.

The two halves of the housing are screwed together with two stainless steel screws and fit on handlebars with a diameter of 22 mm or 1 inch.

The case is also available polished. Then, of course, without the contrasting look. If there is not enough space for a mo.switch mini on the right-hand side of the handlebar due to a large throttle grip, two button housings can also be mounted on the left-hand grip. The six buttons and symmetrical milling create a special eye-catcher.

The mo.switch mini forms a super stylish handlebar design with the mo.grip aluminum grips or the mo.grip soft rubber grips as well as the mo.blaze disc handlebar end blinker and the mo.rear mirror. This modular and high-quality grip-armature-turn signal system adorns the cafe racer as well as any other handlebar.

In conjunction with an electronic push-button control (not included), these beautiful CNC-manufactured fittings can switch all electrical units such as lights, indicators, electric starter, horn and much more.

• Inner diameter: 22 mm or 1 inch
• Outer diameter: 45 mm
• Width: 14 mm

• mo.switch mini aluminum housing
• 3 integrated high-quality buttons per unit
• Stainless steel M5 fastening screws