Global innovation: The m-Flash digital flasher unit from motogadget


It doesn't get any smaller and simpler! The m-Flash unit replaces all conventional flasher relays.

Advantages:

  • Ultra small and light, only one cable with a tiny device the size of a piece of candy for all intents and purposes


  • Ideal for custom bikes and modifications with limited space - no clumsy standard flasher relay


  • Can be routed e.g. in handle bar, frame tubing or in the cable harness


  • Almost load-independent (min. 1 Watt) - constant and correct flashing rate always


  • Thus suitable for almost all LED blinkers, all micro-blinkers, 10 watt blinkers, 21 watt blinkers, etc.


  • Works with e.g. 4 signal lights or 2 handlebar end blinkers, etc.


  • Immediate, lossless and brighter blinker response


  • Super easy connection via two cables only - simply connect in series


  • Absolutely watertight


  • Short circuit proof, automatic overload protection


  • Generates no heat during operation


  • Operating voltage 5V to 18V


  • Also suitable for 6V blinkers


  • Quality 'made in Germany' - from motogadget


    • Dimensions:
    Casing L x W x H: 18 mm x 13 mm x 9,.5 mm
    Connecting cable length: approx. 2 x 50 mm
    Weight: approx. 4 g

    Price: 30,00 € incl. VAT (25,21 € excl. VAT)
    All prices are excl. shipping
    For customers from non-EU countries we do not charge VAT
    For currency conversion please use XE.com Personal Currency Assistant

    Attention: If you want a flasher relay with automatic switch-off, please see m-Stop!

    Notes due to many inquiries:
    a) The m-Flash replaces a conventional flasher relay. This flasher relay normally sits BEFORE the blinker switch viewed in the circuit. If the m-Flash is also used BEFORE the flasher switch, you need only ONE m-Flash. You would only need two m-Flashes if used AFTER the flasher switch. Thus one module for each flasher circuit (left/right). Of course, this is also possible. Please compare to the following circuit diagram.
    The easiest option to install the m-Flash is to find the original relay and simply replace it with the m-Flash.

    b) The m-Flash cannot replace the button control unit when using only push button controls.

    c) For newer Harley-Davidson™ models, the flashers are controlled by a special module (TSM/TSSM). The m-Flash cannot replace or supplement these modules.











    Comparison to electromechanical flasher relays